SalFPS3
From Avisynth wiki
(Difference between revisions)
m (→Requirements: correction) |
Raffriff42 (Talk | contribs) m (link fix) |
||
| Line 15: | Line 15: | ||
== Requirements == | == Requirements == | ||
* AviSynth 2.5.8 or greater | * AviSynth 2.5.8 or greater | ||
| − | * [[Progressive]] input only | + | * [[Interlacing_and_deinterlacing|Progressive]] input only |
* Supported color formats: [[YV12]] | * Supported color formats: [[YV12]] | ||
=== Required Plugins === | === Required Plugins === | ||
Latest revision as of 08:57, 12 November 2015
| Abstract | |
|---|---|
| Author | Mug Funky, Didée |
| Version | 3.0 |
| Download | salFPS3.avs |
| Category | Frame Rate Converters |
| License | |
| Discussion | Doom9 Thread |
Contents |
[edit] Description
A modded version of MotionProtectedFPS for extra protection. Originally created by Mug Funky, modded by Didée.
[edit] Requirements
- AviSynth 2.5.8 or greater
- Progressive input only
- Supported color formats: YV12
[edit] Required Plugins
[edit] Syntax and Parameters
- salFPS3 (clip input, float FPS, int "mode", int "protection", int "protection2", int "iterate", int "reset", int "initialise")
- clip input =
- Input clip to be converted.
- clip input =
- float FPS =
- The FPS to be converted to, this value is not optional so it must be specified.
- float FPS =
- int mode = warp
- Modes:
move: construct new frame by moving blockswarpfast: construct new frame by stretching blockswarp: construct new frame by stretching blocks; more accurate than warpfast
- int mode = warp
- int protection = 80
- multiplier value for SumStretchFPSMask.
- int protection = 80
- int protection2 = 20
- thY1 value for mt_edge; low threshold, if the pixel value is less than thY1, the pixel is set to 0.
- int protection2 = 20
- int interate = 2
- iterate value for FindMotion.
- int interate = 2
- int reset = 50
- reset value for FindMotion.
reset=0: motion estimation always uses estimated motion vectors for the previous frame, which forces linear access.reset=50: motion vectors are calculated from scratch every 50 frames, allowing seeking. Lower values will allow faster seeking.
- reset value for FindMotion.
- int reset = 50
- int initialise = 6
- initialise value for FindMotion; higher values increase the accuracy of vectors calculated from scratch, at the cost of increased calculation time.
- int initialise = 6
[edit] Examples
Change frame rate to 23.976:
AviSource("blah.avi")
fps = 24000.0/1001.0 salFPS3(fps)
[edit] External Links
- Download salFPS3.avs : Current Version (recommended).
- Download salFPS.avs : Original Version.
Back to External Filters ←
